JVC LET0021-001A - Manual (Page 22)

English
Page 17
4 5 6
1 2 3
TEST DELAY
PRESET SEA MODE
SURR MODE
7/P 8 9
10 +10
– +
CENTER
– +
REAR
4. Press MEMORY again while the selected channel number is flashing on the display.
The selected channel number stops flashing. The station is assigned to the selected channel number.
5. Repeat steps 1 to 4 until you store all the stations you want.
To cancel a stored preset station
Storing a new station on a used number erases the previously stored one.
CAUTION:
The preset channels may be erased in the following cases:
• When you press
POWER to set it in the — OFF position.
• When you unplug the power cord.
• When a power failure occurs.
Tuning in a Preset Station
On the front panel:
1. Press TUNER/BAND so that the Control % % % % % / fi fi fi fi fi / @ @ @ @ @ / # # # # # buttons work for tuner settings.
The lamp above the button lights up.
2. Press Control % % % % % / fi fi fi fi fi until “–PRESET+” appears on the display.
3. Press Control @ @ @ @ @ / # # # # # to select a preset channel.
Each time you press the button, the preset channels change.
• Pressing Control @ changes preset channel in decreasing order.
• Pressing Control # changes preset channels in increasing order.
From the remote control:
1. Press FM/AM.
The last received station of the last selected band is tuned in.
Each time you press the button, the band alternates between FM and AM (MW/LW).
2. Press 10 keys to select a preset channel number.
For channel number 5, press 5. For channel number 15, press +10 then 5.
For channel number 20, press +10 then 10. For channel number 30, press +10, +10 then 10.
MEMORY
TUNER/BAND
FM/AM
RX-530RBK(EF)_0021-001A_En 97.4.24, 0:31 PM 17