JVC XV-NA77SL - Manual (Page 11)

Preparations
9
XV-NA77SL/GNT0036-002B/English
Prep
arat
io
ns
Connecting to a digital audio device
You can enjoy sound of enhanced quality by connecting the unit’s
DIGITAL OUT (either OPTICAL or COAXIAL) jack to a digital
input of an amplifier, etc., using an optical or coaxial digital cable.
The digital audio signal on a disc will be transferred directly from
the unit. If the connected digital audio equipment is a Dolby
Digital or DTS decoder or an amplifier with a built-in decoder, you
can enjoy high-quality surround sound.
NOTES
• Connect the unit and the digital audio device by using either an
optical digital cable or a coaxial digital cable.
• It is not recommended to use the digital jacks for dubbing.
When recording the sounds (DVD AUDIO, DVD VIDEO, SVCD,
Video CD or Audio CD) played back on the unit, record them
through the analog jacks (in this case, set [ANALOG OUT] in
the [AUDIO] preference display to [2-CH STEREO]) (see page
39).
• Depending on the disc, no signal may be output from the
DIGITAL OUT. Make an analog connection in this case.
• Set [DIGITAL AUDIO OUTPUT] in the [AUDIO] preference
display correctly according to the connected digital audio
equipment. If setting made for [DIGITAL AUDIO OUTPUT] is
incorrect, loud noise may be generated causing damage to
the speakers (see page 39).
RIGHT
LEFT
DVD
COAXIAL
OPTICAL
DIG ITAL
IN
IN
RIG HT
REA R
LEF T
COA XIA L
OPT ICA L
PCM /ST REA M
DIGIT AL OUT
AUD IO OUT
VID EO
S-V IDE O
Y
P B
P R
VIDEO SIGNAL SELECT
OR
AV COMPU LINK
PAL Y/C
NTSC
REM OTE
RGB /CO MP.
VIDEO OUT
COMPONENT
AV OUT
SUB -
WO OFE R
CEN TER
The unit
Audio cable (supplied)
Digital equipment
Optical digital cable (not supplied)
Coaxial digital cable (not supplied)
XV-XV-NA77SL[B].book Page 9 Thursday, July 31, 2003 8:04 PM