JVC KD-S790 - Manual (Page 22)

22
ENGLISH
Changing the standard plate
This section is only for KD-SC800.
You can change the standard plate with another
plate supplied with your unit.
You can also download them by visiting
.
• When changing the plate, be careful not to
leave your fingerprints on the plate or cover.
1
Loosen the screws with the supplied
hex screwdriver.
2
Remove the plate cover and the
standard plate.
3
Replace with another plate (a
standard, cutout, or downloaded
plate) of your preference.
• When attaching a standard plate
Plate cover
Standard
plate
• When attaching a cutout or downloaded
plate
Add the transparent plate (supplied)
between the cutout or downloaded plate
and the plate cover in order to attach the
plate cover in place.
Notes:
• Be sure to keep the hex screwdriver for future use.
• Two spare screws for the plate cover attachment are
provided with the unit. (See the Installation/
Connection Manual.)
• When you attach the plate cover, do not tighten the
screws too hard; otherwise, the plate cover might be
cracked.
How to use the cutout plates
1 Unfold the supplied cutout plates.
2 Cut the plates out using a scissors.
3 Trim out the window and two knobs using a
knife on a rubber mat.
Plate cover
Standard
plate
Plate cover
Cutout or
downloaded plate
Transparent plate
(supplied)
EN19-22_KD-SC800_S790[J]f.p65 12/9/02, 4:45 PM 22