JBM electronic C-130 - Manual (Page 9)

Page -9-
Copyright
©2007 JBM Electronics, Inc.
Cellular Card Configuration
Your JBM Gateway is able to detect many cellular cards, but others must still be
configured manually. If you are using either one of the older 1xRTT/CDMA cards, or a
GPRS/EDGE/HSDPA card that requires the use of a userid, password, and APN, you will
need to configure your car manually, as covered in the next section.
If you are using any of these cards you will need to work through this section:
GPRS/Edge/HSDPA
Sierra Wireless: 750, 775, 860
Sony Ericsson: GC-83
If you are using one of the newer 1xRTT/1xEVDO, USB Serial based cards, your JBM
gateway has probably automatically detected, configured, and activated your cellular
connection for you, so you can skip this section and proceed to the next section to verify
your cellular connectivity.
If you are using any of these cards you can skip this section:
1xRTT/1xEVDO
Audiovox/UTSStarcom: 5740
Kyocera: KPC-650
Novatel: S/V-620, S/V-720
Sierra Wireless: 555, 580, 5220
Navigate through the GAU menus to the screen Cellular Configuration Screen shown
below: