JVC FS-A52 - Manual (Page 28)

– 25 –
Listening to External Equipment
You can listen to external equipment such as an MD
recorder.
• First make sure that the external equipment is properly
connected as follows:
1
Press AUX/MD.
“AUX” appears on the display.
2
Adjust the volume level to the minimum position.
3
Start playing the external equipment.
• For operation of the external equipment, refer to its
manual.
4
Press VOLUME + / – to adjust your desired
listening level.
5
Apply sound effects, if you wish.
• Press AHB PRO if you want to reinforce the bass
sound.
(See “Reinforcing the Bass sound” on page 12.)
• Press SOUND MODE if you want to control the
tone.
(See “Selecting the Sound modes” on page 12.)
Recording from This Unit
to External Equipment
You can record from this unit to external equipment
connected to the OPTICAL DIGITAL OUT terminal of this
unit, such as an MD recorder.
• The recording level is not affected by the VOLUME level
and sound effect, either.
• First make sure that the external equipment is properly
connected as follows:
1
Prepare for recording on the external equipment.
2
Start recording on the external equipment.
• For operation of the external equipment, refer to its
manual.
3
Play the CD Player of this unit.
• For the CD operation, see page 17 to 21.
To check the clock time while listening to the
external equipment
On the remote control ONLY:
Press DISPLAY (not on number buttons.)
• Each time you press the button, “AUX” and the clock
time alternate on the display.
OPTICAL DIGITAL OUT
terminal
Protective cap
Before connecting the other equipment,
remove the protective cap from the
terminal.
Audio equipment with
an optical digital input
R
SPEAKER IMPEDANCE
L
MIN 4
R L
A C I N
Analog audio
equipment
LINE IN
(AUX)
To output
EN22-25FS-A52[J]ff.pm6 02.1.29, 16:46 25