beautypg.com

Playing back a tape – JVC FS-A52 User Manual

Page 26

background image

– 23 –

To stop during play, press

7.

To fast-wind or rewind the tape, press

¢ or 4.

When the tape direction is

¢ : Fast-winds the tape.

4 : Rewinds the tape.

When the tape direction is

4 : Fast-winds the tape.

¢ : Rewinds the tape.

To eject the cassette, press TAPE open/close

0.

• After ejecting the cassette, press TAPE

open/close

0

again to close the electronic swing panel.

DO NOT press TAPE

open/close

0 during tape play.

To play both sides—Reverse Mode

You can set the cassette deck to play just one side of a tape,
both sides once, or both sides continuously.
• You can set this mode only when a cassette is already in

the cassette deck.

On the remote control ONLY:
Press REV. MODE.
• Each time you press the button, the reverse mode

changes as follows:

: To only play back one side (front or reverse.)
: To play back the front and reverse sides once.
: To play back both front and reverse sides

continuously.

To check the clock time while playing back a tape

On the remote control ONLY:
Press DISPLAY (not on number buttons.)
• Each time you press the button, the source information

and the clock time alternate on the display.

The use of the C-120 or thinner tape is not
recommended, since characteristic deterioration
may occur and this tape easily jams in the pinch
rollers and the capstans.

Playing Back a Tape

You can play back type I, II, and IV tapes.

1

Press TAPE open/close

0 on the unit.

The unit automatically turns on, the electronic swing
panel slides downward, and the cassette loading slot
appears.
If a cassette is already in the cassette loading slot, it is
ejected.

2

Insert a cassette with the exposed part facing left.
The cassette is pulled in, then the electronic swing
panel slides upward automatically.

3

Press TAPE

2 3.

The tape starts playing.
• Each time you press the button, the tape direction

changes as follows:

: Plays the front side.
: Plays the reverse side.

Reverse mode

Tape direction

Tape indicator

When the tape plays to the end, the cassette deck
automatically stops if the reverse mode is set to

or

. (See “To play both sides—Reverse Mode”.)

cassette loading slot

EN22-25FS-A52[J]f.pm6

02.1.21, 10:58

23