Cv-m532, Pin assignment – JAI CV-M532 User Manual
Page 7
- 6 -
CV-M532
Pin no.
Signal
Remarks
1
GND
2
+12 V DC input
3
GND
4
Video output
Parallel with the BNC video output. Avoid double termination.
5
GND
6
HD input/output
HD in as factory setting. *1)
7
VD input/output
VD in as factory setting. *1) *2)
8
GND
9
NC
NC as factory setting. Pixel clock output. *1)
10
GND
11
+12 V DC input
12
GND
5. Pin Assignment
5.1. 12-pin Multi-connector (DC-IN/SYNC.)
Type: HR10A-10R-12PB (Hirose) male
Seen from rear.
Notes:
*1) Signals on pin no. 6, 7 and 9 can be changed by jumper setting.
See “7.3. Jumper Settings” for more information.
*2) In Edge Pre-select and Pulse Width Control mode do not input ext. VD signal.
Pin no.
Signal
Remarks
1
NC
2
EEN output
* Note
3
GND
4
NC
5
Ext. Trig input
* Note
6
WEN output
* Note
5.2. 6-pin Multi-connector (TRIGGER)
Type: HR10A-7R-6PB (Hirose) male
Seen from rear.
* Notes:
The functions available on the 6-pin multi-connector are not effective in
long time exposure mode.