JAI CV-M532 - Manual (Page 18)

- 17 -
CV-M532
7.3. Jumper Settings
Caution on Jumper Setting.
Before making any mode or jumper setting turn the power OFF.
Jumpers for mode setting are found on the boards PK8054 & PK8057.
The following modes are available with jumper setting:
Input/Output Mode of HD/VD signal. (HD/VD input is factory setting)
Edge Pre-select Mode. (Factory setting)
Pulse Width Control Mode
Start/Stop Trigger Mode
Long Time Exposure Mode
Set the jumpers according to the list below in 7.3.1. and 7.3.2.
The jumper positions are shown in “7.4.1. Board 8054 Side B” and “7.4.2. Board 8057 Side A”.
Switch SW2 on PK8057 is shown in “7.2. SW2 on PK8057 Board”.
Jumper
HD/VD in/out External trigger modes
Remarks
Ext.
HD/VD
input *)
Int.
HD/VD
output
Edge pre-
select
Pulse
width
control
Start/
stop
trigger
Long time
expose
JP1 Short Open Short Short Short Short HD input /output. Factory set input
HD input /output. Factory set input
JP2 Open Short Open Open Open Open
JP3 Short Open Short Short Short Short VD input /output. Factory set input
VD input /output. Factory set input
JP4 Open Short Open Open Open Open
JP5 Short Short Short Short Short Short
JP6 Open Open Open Open Open Short Long time integration
JP7 Short Short Short Short Open Short
JP8 Open Open Open Open Short Open
JP9 Open Open Open Open Short Open
JP10 Open Open Open Open Short Open
JP11 Open - - - - - Pixel clock out. Factory set OPEN
JP12 Short Short Short Open Short Short Pulse width
SW2-1 ON - ON ON ON ON HD in 75 Ohm term. Factory set ON
SW2-2 ON - ON ON ON ON VD in 75 Ohm term. Factory set ON
Jumper
HD/VD in/out External trigger modes
Remarks
Ext.
HD/VD
input *)
Int.
HD/VD
output
Edge pre-
select
Pulse
width
control
Start/
stop
trigger
Long time
expose
R127 Short Short Short Short Open Short Factory set SHORT
7.3.1. Jumper on PK8054 Board
*) Factory Setting
7.3.2. Jumper on PK8057 Board
*) Factory Setting
7.3.3. Pixel Clock Output
To use pixel clock output (TTL level: 4.0 V), make the jumper JP11 on PK8057 board shorted-circuited. The
jumper position is shown in “7.4.1. Board PK8057 Side A”.
Pixel clock pulse will be output from pin no.9 of 12-pin multi-connector.
Caution for Pixel Clock Output.
When the pixel clock is enabled, it may cause interference with external equipment if it not properly
shielded.