Jacuzzi OPTICATM 300 User Manual
Page 5
1st Position
2nd Position
50
70
50
70
70
70
40
85
3rd Position
61
79
67
83
74
89
70
101
4th Position
68
83
75
90
84
97
84
110
5th Position
74
87
85
96
91
104
95
117
6th Position
79
90
91
101
99
110
103
125
7th Position
82
93
97
104
104
115
109
130
8th Position
85
95
104
107
108
118
115
135
(Factory Set)
9th Position
89
100
117
111
115
124
124
141
10th Position
98
105
134
121
128
136
140
153
11th Position
111
115
138
133
149
151
165
172
Setting of limiter
The fi rst position of the Rotational Limit Stop (the Limiter) is that position that restricts the rotation of the stem the
most and is at the maximum counterclockwise setting. According to industry standards, the maximum allowable
temperature of the water exiting from the valve is 120°F. This temperature may vary in your local area. The Rota-
tional Limit Stop may need to be readjusted if the inlet water temperature changes. For instance, during the winter,
the cold water temperature is colder than it is during the summer which could result in varying outlet temperatures.
Typical temperature for a comfortable bath or shower is between 90°-110°F.
SHUT OFF ZONE: NO FLOW APPROXIMATELY 0-20 DEGREES OF HANDLE ROTATION
Cold Hot
70°F 160°F
Cold Hot
85°F 180°F
Cold Hot
40°F 180°F
Cold Hot
50°F 160°F
Cold Hot
70°F 140°F
Cold Hot
50°F 140°F
Cold Hot
70°F 120°F
Cold Hot
50°F 120°F
MIX TEMPERATURE-VS-POSITION OF ROTATIONAL LIMIT STOP
APPROXIMATE MIX TEMPERATURE (°F) WITH VARYING INLET TEMPERATURES
WARNING: This is a guide to help you set the Rotational Limit Stop. This is only a guide and should be verifi ed by
following the instructions on setting the rotational limit stop given in this installation and instruction sheet.
Setting of limiter
©1995 Jacuzzi Whirlpool Bath G570000 D 12/06
Page 5