Regular timer programming, Enter programme date, Enter channel position – JVC HR-J438E User Manual
Page 23: Set tape speed (j438e only), Return to normal screen, Engage recorder’s timer mode, Access timer program- ming screen, Access programme screen, Enter programme start time, Enter programme stop time
23
Regular Timer
Programming
– P1 –
START
STOP
21 : 00
22 : 00
SP
ON
DATE
TV PROG
25. 12
1
ARD
[+/ –]
=
SP
M
D
ENTER PROGRAMME DATE
5
Press DATE +/–. (The current date appears on screen.
The date you enter appears in its place.)
ENTER CHANNEL
POSITION
6
Press TV PROG. +/–.
● If you’re not receiving
PDC/VPS, press NUMBER
key “7” to set
to
"OFF" (
੬
pg. 24).
SET TAPE SPEED
(J438E ONLY)
7
Press SP/LP to set the tape speed.
RETURN TO NORMAL
SCREEN
8
After confirming all information is correct, press OK
and the normal screen appears.
● Repeat steps 1–8 for each additional programme.
ENGAGE RECORDER’S
TIMER MODE
9
Press TIMER.
To Timer-Record Weekly Or Daily Serials . . .
. . . anytime during steps 2 through 8, press WEEKLY (NUMBER
key “9”) for weekly serials or DAILY (NUMBER key “8”) for
daily serials (Monday–Friday).
NOTES:
●
To timer-record from a satellite tuner connected to your
recorder's AV2 IN/DECODER connector, press TV PROG. +/–
in step 6 above to set the channel position to "AUX2".
●
You can programme this recorder to timer-record as many as
8 programmes. If you try to programme the recorder to record
a ninth, "PROGRAM FULL" appears on screen and "FULL"
appears on the front display panel. To record the extra
programme, you must first cancel any unnecessary
programmes (
੬
pg. 24).
If you don’t know the SowView number for the programme you
wish to record, use the following procedure to set your recorder
to timer-record the programme.
Remember, the clock must be set before you can programme
the timer (
੬
pg. 7).
Turn on the recorder first and perform the following steps.
ACCESS TIMER PROGRAM-
MING SCREEN
1
Press PROG.
ACCESS PROGRAMME
SCREEN
2
Press START +/–. (If you’re
just starting out, “P1”
appears.)
The front display panel looks like this:
ENTER PROGRAMME
START TIME
3
Press START +/– to enter
the time you want
recording to start.
● Press and hold START
+/– to move in 30-
minute increments, or
press and release
repeatedly to move 1
minute at a time.
The front display panel looks like this:
ENTER PROGRAMME STOP
TIME
4
Press STOP +/– to enter the time you want recording to
stop.
SP
– P1 –
START
STOP
21 : 00
– : – –
SP
ON
DATE
TV PROG
25. 12
– –
[+/–]
=
SP
– P1 –
START
STOP
– : – –
– : – –
SP
ON
DATE
TV PROG
25. 12
– –
[+/–]
=