JVC KD-LX50 - Manual (Page 29)

29
ENGLISH
STOP
PLAY
9
Speak the same word(s) again while “REPEAT” is flashing on
the display. (In this example, speak “Turn off.”)
“CHECK” appears on the display while recording your voice.
“OK” appears when
recording is complete.
“ ” on the display means that your own voice is recorded for this voice
command.
If the recording fails
A beep sound comes out and the display goes back to the one shown in step 6.
10
Repeat steps 6 to 9 to record your own voice for other preset
Operation Commands (VOICE 02 to VOICE 13).
11
Press and hold VOICE again to finish the recording.
To make the system recognize and accept the preset voice
commands anyone speaks
Set “VOICE WORD” to “STANDARD” by following steps 1 to 4 on page 27. (In step 3, press +
to select “STANDARD.”)
To erase your own voice from the Operation Commands
See “To erase the voice commands” on page 37.
EN22-39.KD-LX50[J]/f 00.3.15, 4:12 PM 29