JVC Model DLA-HX1E - Manual (Page 54)

54
What to do when these messages are displayed
When the “Lamp time” reaches 1000 hours
[
A message indicating “1000h” appears on the projected screen.
• Press [EXIT] button to delete the message.
When the accumulated lamp time reaches between 1900 hours to 2000 hours,
“Lamp replacement” message appears on the screen each time the projec-
tor is turned on.
• Press [EXIT] button to delete the message.
[ Prepare a replacement lamp and install as quickly as possible.
The word “Warning” appears and blinks when the accumulated lamp time
reaches 2000 hours.
The message can be cleared by pressing the [EXIT] button. However, the
same message will re-appear every hour.
Once the projector is turned off, it cannot be turned on again if the accumu-
lated lamp time has exceeded 2000 hours.
When the accumulated lamp time reaches 2010 hours, the projector shuts
down and cannot be turned on again.
[
Replace the light-source lamp and reset the lamp time.
(
☞ page 47, 48, 49)
Message Cause (Contents)
Note
• The message display language corresponds to the menu language
setting. This is set to [English] when the projector is bought. The dis-
play language can be selected from among 8 languages. (
☞ page 39)
However, the input mode ([PC1], [PC2], [PC3], [Y/C], [VIDEO]) and
button indications ([FREEZE], [D.ZOOM], [EXIT]) are only displayed in
English irrespective of the display language setting.
1000h
EXIT
Lamp replacement
EXIT
Lamp replacement
EXIT
Warning
HX-1E_p50-61_En.p65 10/3/03, 6:11 PM 54