JVC DVL320U - Manual (Page 38)

3-2
1. Torque driver
Be sure to use to fastening the mechanism and exte-
rior parts because those parts must strictly be control-
led for tightening torque.
2. Bit
This bit is slightly longer than those set in conventional
torque drivers.
3. Tweezers
To be used for removing and installing parts and wires.
4. Chip IC replacement jig
To be used for adjustment of the camera system.
5. Jig connector cable
Connected to CN105 of the main board and used for
electrical adjustment, etc.
6. Communication Cable
Connect the Communication cable between the PC
cable and Jig connector cable when performing a PC
adjustment.
7. PC cable
To be used to connect the VideoMovie and a personal
computer with each other when a personal computer
is used for adjustment.
8. Service support system
To be used for adjustment with a personal computer.
3.2 SETUP
1. Setup for electrical adjustment with personal computer.
NOTE: Remove one screw (1) first and the cover (JIG)
next.
Fig. 3-2-1 Connection for Service support system
9. Alignment tape
To be used for check and adjustment of interchange-
ability of the mechanism.
10. INF adjustment lens
To be used for adjustment of the camera system.
11. INF adjustment lens holder
To be used together with the camera stand for operat-
ing the VideoMovie in the stripped-down
condition such as the status without the exterior parts
or for using commodities that are not yet conformable
to the interchangeable ring.
12. Camera stand
To be used together with the INF adjustment lens
holder.
13. Light box assembly
To be used for adjustment of the camera system.
14. Gray scale chart (for Light box assembly)
To be used for adjustment of the camera system.
15. Color bar chart (for Light box assembly)
To be used for adjustment of the camera system.
Service Support System
RS232C
COM Port
PC CABLE
Personal Computer
MENU
RED
to CN105-8 pin (CN2-1 pin)
( JLIP_RX )
WHITE
BLACK
to CN105-22 pin (CN1-13 pin)
( JLIP_TX )
to CN105-7 pin (CN1-12 pin)
( GND )
COMMUNICATION CABLE JIG CONNECTOR
1
Cover(JIG)
COMMUNICATION CABLE
CN105
Jig connector cable