JVC DVL320U User Manual

Page 27

2-11

Fig. 2-4-11

7. 7a Loading brake assembly/ 7b Guide pin (S)

7c Pad arm assembly/ 7d Slide guide plate assembly

7e Collar/ 7f Collar/ 7g Sub brake assembly

7h Control plate assembly

Note 7a:
Don’t remove these parts unreasonably. If they are removed
for some reason, be very careful not to lose them.

Note 7b:
When reinstalling the sub brake assembly, set the control
plate assembly so that its hook is set in the

part of the

sub brake assembly.

Note 7c:
Since the slide guide plate assembly controls the slide deck
assembly so that it exactly slides the main deck assembly, it
must exactly be assembled in the PLAY mode. Therefore,
temporarily fix the slide guide plate assembly in this stage.
For details of reassembling procedure, refer to “2.6.1
Assembling slide deck assembly and main deck as-
sembly” .

Note 7d:
The pad arm assembly controls the tension level of the
tension arm assembly. For adjustment of the tension arm
assembly, refer to “2.6.2 Locating tension pole”.

Note 7e:
When reinstalling the load brake assembly, slightly lift the
slide deck assembly upwards because the lower part of the
load brake assembly sticks out of the slide deck assembly.

Fig. 2-4-12

8. 8a Tension lever assembly/ 8b Slide lever assembly

8c Brake control lever assembly

Note 8a, 8b, 8c:
For refitting the respective parts, refer to the following fig-
ures

(W7)

(P7d)

Note 7e

Note 7c

Note

Note 7b

Note 7d

(L7a)

(W7)

(S7b)

(S7a)

(P7a)

(P7b)

(P7c)

(L7b)

(L7d)

(L7c)

Note 8c

Note

Note 8a

Note 7b

8a Tension lever assembly

8b Slide lever assembly

8c Brake control lever
assembly

This manual is related to the following products:

DVL720U DVL522U