Electrical connections, Electrical requir, Suppl – John Lewis JLBIGH702 User Manual

Page 7

Electrical Connections

THIS HOB MUST BE EAR

THIS HOB MUST BE EARTHED

THED

THED.....

Any electrical work required to install this hob should
be carried out by a qualified electrician or competent
person, in accordance with the current regulations.

Electrical Requir

Electrical Requirements

ements

Any permanent electrical installation must comply with the
latest I.E.E. Regulations and local Electricity Board
regulations. For your own safety this should be undertaken
by a qualified electrician, e.g. your local Electricity Board,
or a contractor who is on the roll of the National Inspection
Council for Electrical Installation Contracting (NICEIC).

Electrical Connections

This hob is designed to be connected to a 230 V 50 Hz AC
electrical supply.
Before switching on, make sure the electricity supply voltage
is the same as that indicated on the hob rating plate. The
rating plate is located on the bottom of the hob. A copy is
attached on the back cover of this book.

The hob is supplied with a 3 core flexible supply cables.
This has to be provided with a proper plug, able to support
the load marked on the identification plate. To connect the
plug to the cable, follow the recommendation given in diagram
aside. The plug has to be fitted in a proper socket.
In the event of having to change the fuse, a 3amp ASTA
approved (BS 1362) fuse must be used.
Should the plug need to be replaced for any reason, the
wires in the mains lead are coloured in accordance with the
following code:

Green and Yellow

- Earth

Blue

- Neutral

Brown

- Live

— Connect the green and yellow (earth) wire to the

terminal in the plug which is marked with the

letter 'E' or the earth symbol

or coloured green

and yellow.

— Connect the blue (neutral) wire to the terminal

in the plug which is marked with the letter 'N' or
coloured black.

— Connect the brown (live) wire to the terminal in

the plug which is marked with the letter 'L' or
coloured red.

Upon completion there must be no cut, or stray strands of
wire present and the cable clamp must be secure over the
outer sheath.

A cut off plug inser

A cut off plug inserted into a 13 amp sock

ted into a 13 amp sock

ted into a 13 amp socket

is a serious saf

is a serious safety (shock) hazar

ety (shock) hazar

ety (shock) hazard.

d. Ensur

Ensur

Ensure that

e that

the cut off plug is disposed of saf

the cut off plug is disposed of safel

elyyyyy.....

PPermanent Connection

ermanent Connection

In the case of a permanent connection, it is necessary that
you install a double pole switch between the hob and the
electricity supply (mains), with a minimum gap of 3 mm
between the switch contacts and of a type suitable for the
required load in compliance with the current electric
regulations.
The switch must not break the yellow and green earth cable
at any point.

Ensur

Ensure that the hob suppl

e that the hob suppl

e that the hob supply cable does not

y cable does not

come into contact with surfaces with

come into contact with surfaces with
temperatur

temperatur

temperatures higher than 50 deg.

es higher than 50 deg.

es higher than 50 deg. C

C .....

Min. size Cable/flex

Cable / flex type

Fuse

0.75 mm

H05 V2V2-F (T90)

3 A

Suppl

Supply cable r

y cable r

y cable replacement

eplacement

The cable used to connect the hob to the electrical supply
must comply to the specifications given below.

Neutral

Earth (yellow/green)

The manufacturer declines any liability should

The manufacturer declines any liability should
these safety measures not be observed.

these safety measures not be observed.