Jet Tools C US JMS-12SCMS - Manual (Page 13)

13
Installing the Safety Hold-down Clamp
1. Place the hold-down clamp assembly (A, Fig. 4)
in a mounting hole located behind the right or left
fence (B, C).
2. Thread the hold-down clamp knob (D) into the
hole located at the rear of the saw base.
3. Tighten the hold-down clamp knob (D).
Power Cord Storage Clips
The slide carriage has two clips on the rear for cord
storage when the machine is not in use.
To assemble:
Attach each storage clip (A, Fig. 5) to the rear of
slide-bar seat (C) with one mounting screw (B).
Saw Blade Wrench
For convenience, storage clip (A, Fig. 6) is located
at the left rear foot of the base for storing the blade
wrench (B).
Figure 4
Fi
Figure 5
Figure 6