JVC CX-7000 Series - Manual (Page 61)

Installing the Retransfer Film
Cautions:
v
Stand the cassette on a flat surface as illustrated in the diagram.
Avoid doing so on the floor as dust attached to it may cause printing
errors.
.
v
Do not touch the retransfer face (the side that faces outward when
installed) with your hand. Touching it may cause printing errors. Put
on the supplied gloves when handling the retransfer film.
v
The cassette is heavy when the retransfer film is loaded. To prevent
the cassette from dropping during handling, make sure to hold it with
both hands.
v
When installing a new film, make sure that at least three black lines
are wound onto the take-up side. Insufficient winding may cause the
printer to malfunction.
v
Do not perform any work on the printer door. Do not place heavy
objects or apply load on the printer. Doing so may damage it.
1 Open the printer door
.
2 Press and hold down the cassette button, and remove the retransfer
film cassette (on the left)
.
3 Install a new retransfer film
v
Install while referring to the indication on the label of the cassette.
A
When installing the retransfer film, make sure that at least three
black lines are wound onto the take-up side.
.
B With the retransfer face facing outward, align the unused side of
the film with the arrow on the cassette, and unwind it along the
three shafts.
C Insert the retransfer film firmly into the bobbin holders with the film
set to the far end of the guides.
v
A: take-up side (black)
v
B: unused side (green)
.
4 Remove any slack in the film
A Hold the retransfer film cassette.
B Turn the knob in the direction indicated by the arrow.
.
5 Insert the cassette all the way in along the guide rail until a “click”
sound is heard, followed by closing the printer door
.
.
Cautions:
v
While in the transport mode, the retransfer film cassette cannot be
installed to the printer with the retransfer film loaded. With the printer
door closed, turn on the power to cancel the transport mode.
"Transport Mode Setting" (A page 29)
Setup
61