JVC CA-MXGA77 - Manual (Page 30)

27
SET
SET
SET
ECO
STANDBY
Using Recording Timer
With Recording Timer, you can make a tape of a radio
broadcast automatically. You can set the timer whether the
unit is on or off.
How Recording Timer actually works
The unit automatically turns on, tunes in to the specified
station, sets the volume level to “VOL MIN,” and starts
recording when the on-time comes (the
indicator flashes
while the timer is operating). Then, when the off-time comes,
the unit automatically turns off (stands by).
Recording Timer works only once, but the timer setting
remains in memory until you change it.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 2
again.
• If you have made a mistake while setting the timer, press
CANCEL/DEMO. (However, this does not always work. If
CANCEL/DEMO does not work, press CLOCK/TIMER
repeatedly and start from step 2 again.)
On the unit ONLY:
1
Put a recordable cassette into deck B.
2
Press CLOCK/TIMER
repeatedly until “REC”
appears on the display.
indicator lights up and the REC (recording timer)
indicator starts flashing on the display.
• Each time you press the button, the clock/timer setting
modes change as follows:
DAILY
Canceled ON TIME
(Recording Timer)
CLOCK
(See page 9.)
REC ON TIME
(Daily Timer)
CLOCK
/ TIMER
CLOCK
/ TIMER
WOOFER
3
Press CLOCK/TIMER again.
“ON TIME” appears for 2 seconds, then
the unit enters on-time setting mode.
4
Set the on-time you want the unit
to turn on.
1) Turn the 4/¢ control to set the
hour, then press SET.
2) Turn the
4/¢ control to set the
minute, then press SET.
“OFF TIME” appears for 2 seconds,
then the unit enters off-time setting
mode.
5
Set the off-time you want the unit
to turn off (on standby).
1) Turn the 4/¢ control to set the
hour, then press SET.
2) Turn the
4/¢ control to set the
minute, then press SET.
The unit enters preset station selecting
mode.
6
Select the preset station.
1) Turn the 4/¢ control to select the
band (“TUNER FM” or “TUNER AM”),
then press SET.
2) Turn the
4/¢ control to select a
preset channel number, then press SET.
The REC (recording timer) indicator stops
flashing and remains lit. The settings you
have done are shown on the display in
sequence for your confirmation.
7
Press to turn off the unit (on
standby) if necessary.
About the recording source
If you change the source while recording, the recording source also
changes.
WOOFER
23_32MXGT88&GA77[B].pm6 03.2.8, 9:03 PM 27