JVC TK-C1481 - Manual (Page 8)

E-8
INTRODUCTION
1 Lens mount
This means to attach the lens.
This is applicable to both the C-mount
lenses and CS-mount lenses.
2 Backfocus adjustment ring
Adjusting the back focus during lens
installation.
When readjustment is required, loosen
the locking screw
3
by tur ning it
counterclockwise and turn the back focus
adjustment ring
2 .
After the adjustment, tighten the locking
screw
3
again.
3
[BF LOCK] Back focus locking screw
This serves to fix the back focus-adjusting
ring.
4 Camera-mounting bracket
The bracket has been attached on the
bottom of the camera before shipment. It
can also be attached on the top
according to the circumstance.
To re-attach the bracket use the threaded
holes at the top, with the camera
mounting bracket locking screws
7 .
5
Camera-mounting screw hole (1/4
inch)
Use this hole when mounting
the camera onto a fixer, pan/
tilt unit, and the like. (Use a
screw shorter than 7 mm.)
6 Rotation-preventive hole
Make use of this rotation-preventive hole
to prevent any fall when mounting the
camera. Make sure that the camera is
securely mounted.
7 Camera mounting bracket fixing screws
(
×2: M2.6 × 6 mm)
Be sure to use a 6 mm long screw.
1
2
3
4
5
6
7
MAX.
7 mm
Controls, Connectors and Indicators