E-11, Rx.term switch – JVC TK-C1481 User Manual

Page 11

E-11

DC12V

AC24V

Y/C OUT

SYNC IN

POWER

VIDEO OUT

SEE INST-

RUCTION

MANUAL

CLASS 2 ONL

Y(U

TYPE)

ISOLA

TED PO

WER ONL

TYPE)

AUX GND

⁄

)

(

ﬁ

›

‹

[DC 12V, AC 24V] Power input terminals
(TK-C1480U and TK-C1480E)
To input DC 12V or AC 24V power.

[TX+A, TX-B, RX+C, RX-D] Control
signal connection terminals
Terminals for inputting signals with
electrical characteristics conforming to
the EIA/TIA RS-422A or RS-485 standard.
੬

RX.TERM switch

[AUX, GND] Auxiliary Output Terminals
If any change occurs in the area that was
set on the MOTION DETECT screen, these
terminals output signals. (

੬ Page 31)

[Open-collector Low signal. Maximum
voltage 30V, Current 30mA.]

[Y/C OUT] Y/C output connector
This 4-pin connector outputs the luminance
and chrominance signal.
• Pin configuration of Y/C OUT connector

[VIDEO OUT] Video signal output
connector
This BNC connector outputs a composite
video signal. Connect this to the video input
connector of a video monitor, switcher, etc.

[POWER] Power indicator lamp
This lamp lights when power is supplied
to the camera.

[SYNC IN] Sync signal input connector
This BNC connector accepts the input of
an external sync signal such as a composite
video (VBS) or black burst (BB) signal.
When a sync signal is input into this
connector, the camera operation is
automatically synchronized with the
external sync signal.
To terminate this connector at 75

Ω, turn

ON the EXT.TERM switch

Power cable (TK-C1481EG)
Connect to the commercial AC230V
outlet

Pin No.

Signal

GND

Luminance (Y)

Chrominance (C)