JBL CS680 (230V) - Manual (Page 5)

5
English
The CS680 satellites and center channel are designed to be mounted
on the wall. There is a fixed-mount wall bracket and an adjustable
wall bracket provided for each satellite and the center channel.
Each speaker bracket will require up to four 1-1/2" #10 wood screws;
each screw should be fastened to a wall stud. If a wall stud is
unavailable, install an anchor appropriate for a 1-1/2" #10 screw.
NOTE: The customer is responsible for the correct selection and use
of mounting hardware (available through hardware stores) that will
ensure the proper and safe wall-mounting of the speakers.
Fixed-Mount Wall Bracket
Step 1. Mark the positions on the wall where you would like to
place the mounting screws.
Step 2. Attach the bracket to the wall using two screws
(not included).
Step 3. Remove the rubber ring on the bottom of the satellite and sit
the satellite or center channel speaker onto the back bracket.
Step 4. Attach 1/4-20" screw into insert on bottom of speaker
and tighten.
Adjustable Wall Bracket
Step 1. Remove cap over threaded insert on rear of speaker.
Step 2. Mark the positions on the wall where you would like to place
the mounting screws.
Step 3. Place bracket against the wall and fasten four 1-1/2" #10
wood screws through the bracket’s screw holes into the wall. If a
wall stud is not available, use an appropriate anchor.
Step 4. Unscrew round collar (C) from bracket (A).
.
Step 5. Screw the ball and shaft assembly (B) to the 1/4"-20 insert on
the back of the satellite or the center channel (do not use the bottom
insert on either speaker). Back out 1/2 of a turn and tighten the nut
against the speaker. If the ball and shaft assembly is not backed out
before tightening the nut, performing Step 8 below may dislodge the
threaded insert in the speaker housing and permanently damage the
speaker.
Step 6. Attach speaker wire as shown on page 6.
Step 7. Drop round collar (C) over ball and shaft assembly (B) that is
mounted to the speaker with the finished side of the collar facing the
rear of the speaker.
Step 8. Carefully push the ball straight into the socket mounted on
the wall, angle the speaker as desired and tighten the collar using
the enclosed metal bar.
Figure 3. Bracket on wall.
Metal bar Metal bar
A
B
C
WALL-MOUNTING THE SATELLITES AND CENTER CHANNEL
31079_CS680_OM_Eng 13/11/06 9:53 Side 5