JVC BR-DV3000U - Manual (Page 42)

42
PLAYBACK
–
Connection/setting
–
This section explains the required connection, setting and operation method for using this
unit as a player.
Connection
Ⅵ Using this unit as a standalone device
DV IN/OUT
AUDIO VIDEO
LINE Y/C CH 1/3 CH 2/4
IN
OUT
REMOTE
SERIAL 9PIN
NTSC/PAL
NTSC PAL
DC12V
Monitor
Y/C (S) video cable
Video cable
Audio cable AUDIO OUT
VIDEO LINE OUT
Y/C (S) OUT
Ⅵ Connecting this unit to a video device with a DV terminal
It can record with almost no loss in image or sound quality.
DV IN/OUT
AUDIO VIDEO LINE Y/C CH 1/3 CH 2/4
IN
OUT
REMOTE
SERIAL 9PIN
NTSC/PAL
NTSC PAL
DC12V
DV
terminal
DV
terminal
Player: the rear panel of the main unit
Monitor
DV cable (available separately)
Another VTR
Ⅵ Connecting this unit to a video device with no DV terminal (analogue signal):
Memo
• Turn the power of both devices OFF and connect the DV cable.
• Do not insert incorrectly (in reverse) the DV cable end to DV port of both devices.
• If the recorder is a GY-DV500 or GY-DV700W, and BR-DV3000 is put to PLAY from the STOP mode, the phase of
the EE audio output from the camcorder will be displaced. There is no problem with the recorded signals.
DV IN/OUT
AUDIO VIDEO
LINE Y/C CH 1/3 CH 2/4
IN
OUT
REMOTE
SERIAL 9PIN
NTSC/PAL
NTSC PAL
DC12V
AUDIO OUT
Y/C
IN VIDEO
IN AUDIO
IN
VIDEO LINE OUT
Y/C (S) OUT
Player: the rear panel of the main unit
Monitor
Y/C (S) video cable
Video cable
Audio cable
Another VTR
BR-DV3000U_p02-49 06.8.24, 2:02 PM 42