JVC EX-D5 - Manual (Page 11)

7
Introduction
This page is for when operating your TV using the
remote control of this product.
Setting the manufacturer's code
1
Slide the remote control mode
selector to the TV side.
2
Keep pressing down TV.
NOTE
Keep pressing down TV until Step 4 is complete.
3
Press ENTER.
4
Press number buttons (1-9, 0).
Ex.:
For a Hitachi TV: Press 0, then 7.
For a Toshiba TV: Press 2, then 9.
If there are more than one manufacturer’s codes,
try them in turn and select the one that causes the
product to work properly.
NOTE
Manufacturer’s codes may be changed without notice.
You may not be able to operate a TV produced by the
manufacturer shown above.
5
Release TV.
For TV operation
Operate the remote control by pointing it towards
the TV.
*1 Make sure to slide the remote control mode
selector to the TV side in advance.
NOTE
When the batteries are replaced, perform the
manufacturer's code setting again.
Operating the TV using
the remote control
WIRELESS
Manufacturer Code Manufacturer Code
JVC 01 Nordmende
13, 14, 18,
26 – 28
Akai 02, 05 Okano 09
Blaupunkt 03 Orion 15
Daewoo 10, 31, 32 Panasonic 16, 17
Fenner 04, 31, 32 Philips 10
Fisher 05 Saba
13, 14, 18,
26 – 28
Grundig 06 Sanyo 05
Hitachi 07, 08 Schneider 02, 05
Inno-Hit 09 Sharp 20
Irradio 02, 05 Sony 21 – 25
Magnavox 10 Telefunken
13, 14, 18,
26 – 28
Mitsubishi 11, 33 Thomson
13, 14, 18,
26 – 28, 30
Miver 03 Toshiba 29
Nokia 12, 34
Turn ON/OFF the power.
Change channels.
Adjust volume.
Select channels.
Alternates between the
previously selected channel
and the current channel.
Switch TV and video input.
100+
9
*1
Getting started
EX-D5[B]_f.book Page 7 Wednesday, June 1, 2005 8:46 PM