JVC CA-HXZ9 - Manual (Page 27)

22
English
Using the Timers
There are three timers available—DAILY (Daily Timer), REC
(Recording Timer), and SLEEP (Sleep Timer).
You can set the timers whether the unit is on or off; however,
if Ecology Mode is activated, you cannot set the timers while
the unit is off.
Before using the timers, set the clock built in the unit. (See
page 10.)
Using Daily Timer
With Daily Timer, you can be wake up with your favorite
music or radio program.
How Daily Timer actually works
The unit automatically turns on, sets the volume level to the
preset level, and starts playing the specified source when the
on-time comes. (“DAILY” and the DAILY indicator flash just
before the on-time, and the DAILY indicator continues
flashing while the timer is operating.) Then, when the off-
time comes (“DAILY OFF” flashes just before the off-time),
the unit automatically turns off (on standby).
The Daily Timer works everyday automatically. If you do not
want to use the Daily Timer, turn it off. (See “To turn on or
off Daily Timer after its setting is done” on page 23.) The
timer setting remains in memory until you change it.
• There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step 1 again.
• To correct a misentry while setting the timer, press
CANCEL/DEMO.
Before you start...
• When using a disc as the source to play—
– Make sure there is a disc on the selected disc tray.
• When using a tape as the source to play—
– Make sure that a tape is in the cassette deck.
– Make sure that the tape direction is correct.
• When using the external component as the source to
play—
– Set the timer equipped on the external component at
the same time.
On the unit ONLY:
1
Press CLOCK/TIMER
repeatedly until “DAILY”
appears on the display.
The (Timer) indicator lights up and the
DAILY (Daily Timer) indicator also starts
flashing on the display.
• Each time you press the button, the timer setting modes
change as follows:
2
Press CLOCK/TIMER again.
“TIMER” appears for about 2 seconds,
then the unit enters on-time setting mode.
3
Set the on-time you want the
unit to turn on at.
1) Turn
4 / ¢ to set the hour, then
press SET/DISPLAY.
2) Turn 4 / ¢ to set the minute,
then press SET/DISPLAY.
“SET” appears for about 1 second, then
the unit enters off-time setting mode.
CLOCK
/ TIMER
CLOCK
/ TIMER
PRESET
SET /
DISPLAY
DAILY
Canceled
TIMER
(Daily Timer setting)
TIMER
(Recording Timer setting)
REC
Clock
setting
(The hour digits start flashing.)
D A I L Y
D A I L Y
D A I L Y
Continued
EN20-25.CA-HXZ9[UW]f.p65 03.1.30, 11:00 AM 22