JBL 9950-0113-001 - Manual (Page 9)

8
950-0113-001 JBL ® Radial Manual
SYMPTOM POSSIBLE PROBLEM SOLUTION NOTE
SOUND QUALITY
Too much bass or treble JBL Radial is being overdriven
by an amplifi ed audio source. Ensure that the JBL Radial is
connected to an appropriate
source device.
Make sure that all signal
cables are inserted snugly into
receptacles.
Volume level may be too high Check volume of source
device.
Some devices will distort the
output signal if the volume is
set to maximum.
Check the EQ setting on your
iPod or source device. JBL Recommends that the
source device EQ be set to
fl at or OFF
JBL Radial emits a loud hum
or buzzing noise. Input cables not plugged in
properly. Check input cable connection.
Speaker system experiences
radio frequency interference
or picks up a radio station. Input cable may be picking up
interference. Wrap up excess input cable
in order to make as short as
possible.