JVC HR-J439EE - Manual (Page 4)

4
EN
INSTALLING YOUR NEW RECORDER (cont.)
Select Televi-
sion System
SET SYSTEM SWITCH
1
Set to the appropriate position depending on your TV
system. (Refer to the chart on the left.)
NOTES:
● If no colours appear on the screen when using a multi-system
television with its system select switch set to AUTO, change
the switch position to correspond to the recorder's RF system
select switch (G or K).
● For more information on multi-system compatibility.
੬
p.22
Major countries Colour TV broadcast Switch
system position
China, Mongolia,
PAL D/K
Rumania
Bulgaria, Czech Rep.,
K
Slovakia, Hungary, SECAM D/K
Poland, Russia
Austria, Denmark,
Finland,Holland, Italy,
Norway, Spain,
PAL B/G
G Switzerland, Sweden,
Germany
Egypt SECAM B/G
Back of recorder
Tune The TV
To Your Video
Recorder
The video recorder sends picture and sound signals via the RF
connecting cable to your TV on UHF channel 36.
TURN ON THE RECORDER
1
Press OPERATE.
SELECT OUTPUT MODE
2
Set the TEST switch on the back of the recorder to ON.
SET TV CHANNEL
3
Set your TV to the video channel (UHF channel 36).
Two white bars appear on screen vertically.
● Tune the TV until the bars are as clear as they can be.
● Your TV should be set to the channel designated for
use with a video recorder, or to a spare channel if
there is not a specified video channel on your TV.
RESET OUTPUT MODE
4
Return the TEST switch to OFF.
NOTES:
● If CH36 is occupied by a local station, adjust the RF output
channel adjustment screw to use another channel between
CH32 and CH40 instead.
● If some interference noise is continually seen on the screen,
consult your JVC dealer.
6
q
OPERATE
TEST
OFF – ON
SYSTEM
K – G