John Lewis JLUCFZW6002 - Manual (Page 7)

7
The appliance should be delivered in its original
packaging; the appliance must always be kept in a
vertical position as indicated by the warnings on the
packaging.
After each transportation the appliance must not be
switched on for approximately 2 hours. this allows the
coolant gases to settle.
After unpacking the appliance, check to see if there is any
damage. If there is damage to the appliance you should
contact the John Lewis branch from which you
purchased it. In that case retain the packaging.
Cleaning
Remove all adhesive tape and internal packaging.
Wash the inside of the appliance using lukewarm water and
mild detergent. Use soft cloth.
After cleaning wipe out the inside of the appliance.
Unpacking
Location
The appliance should be positioned in a well ventilated, dry
room.
Energy use is affected by the ambient temperature.
The appliance should therefore:
not be installed next to radiators, cookers or other
sources of heat
only be installed at a location where the ambient
temperature corresponds to the climate classification, for
which the appliance is designed.
Climate Classification
The climate classification can be found on the serial plate.
The following table shows which ambient temperature is
correct for each climate classification:
Climate Classification Ambient Temperature
SN +10 to +32 °C
N +16 to +32 °C
ST +18 to +38 °C
Ventilation Requirements
The appliance must have adequate ventilation to ensure
correct operation.
Diagram shows the ventilation requirements when
installed:
A: Under a worktop, or cupboard.
The clearance space of 10 cm above the appliance
may be reduced to 5 cm providing a clearance
space 2,5 cm is left on either side of the appliance.
B: When freestanding