Jacuzzi LCD Series - Manual (Page 20)

then repeatedly press the sensor pad to turn the light off or to select one of
6 constant colors illustrated below.
You must press the LIGHT sensor pad within 5 seconds between each “off”
or “color” step in the light sequence to prevent it from resetting. Pressing
the sensor pad after 5 seconds restarts the sequence at “Random” mode.
This mode automatically changes the light color every 8 to 20 seconds.
Note: Any time the spa light is manually turned on, it will automatically turn
off after approximately 1 hour. If you desire more light at this time, simply
turn the light back on.
9.4 Activate Pump 1
The sensor pad labeled JETS 1 controls the 2-speed pump #1.
Pressing this sensor cycles pump #1 from off, to low speed, to
high speed, and back to off.
9.5 Activate Pump 2/Pump 3
On two pump J-350, J-360, J-370 models, the sensor pad
labeled JETS 2 controls the high-speed pump #2. Pressing this
sensor cycles pump #2 on and off.
On the three pump J-380 model, this sensor pad controls both pump #2 and
pump #3 in the following sequence:
A) Press once to turn on pump #2 in high-speed;
B) Press a second time to turn on pump #3 in high-speed;
C) Press a third time to turn off pump 2;
D) Press a fourth time to turn off pump #3.
Auto Turn Off — Anytime a pump has been manually turned on, it will
automatically turn off after approximately 20 minutes. If at this time you
desire more jet operation you may simply turn the pump(s) back on.
9.6 Selecting Desired Massage Action
Your Jacuzzi Premium spa is equipped to allow you to customize the massage
action you desire. Each model incorporates a diverter valve that allow you to
Page 16
Spa Light Sequence
OFF RED OFF
OFF
GREEN
TEAL
OFF BLUE
OFF VIOLET
OFF ORANGE
OFF
RANDOM