JVC 240-020-505 - Manual (Page 44)

74
Changing the Signal System (NTSC / PAL)
This DVD recorder supports both the NTSC and PAL signal systems.
The signal system can be altered at the TV TYPE item on the SYSTEM(2/2) menu screen, or via the following procedure.
The signal system can be changed even when the monitor is not connected.
Operation Procedure
1. Set this unit to the Stop mode.
2. Press and hold the SETUP and STOP buttons simultaneously for approximately 3 seconds.
● This changes the signal system. When this is done, the unit will turn off automatically and rebooted.
Others
This product uses partial third-party software.
For information concerning the software used, login via FTP by
inputting the following into the unit and view the readme.txt file:
User: anonymous
Password: None
(If the IP address of the unit is set to 192.168.0.2, FTP
connection can be established by entering ftp://196.168.0.2 in
the address bar of Internet Explorer.)
75
Specifications
Recording format : DVD Video Version 1.1
Disc format
: ISO9660-compatible UDF
Recordable media : DVD-R For General Version 2.0
DVD-RW Version 1.1
DVD+R / DVD+RW
Recording signals : Must conform to DVD Video Format
Ⅵ Video Signals
DVI input
: T.M.D.S CLOCK
T.M.D.S LINK #0 8bit × 3 (RGB)
Line input : 1.0 V(p-p), 75 1 unbalanced
Y/C input : Y signal = 1.0 V(p-p), 75 1 unbalanced
C signal = 0.286 V(p-p), 75 1 unbalanced (NTSC)
C signal =0.3 V (p-p), 75 1 unbalanced (PAL)
DVI output : T.M.D.S CLOCK
T.M.D.S LINK #0 8bit × 3 (RGB)
Line output : 1.0 V(p-p), 75 1 unbalanced
Y/C output : Y signal = 1.0 V(p-p), 75 1 unbalanced
C signal = 0.286 V(p-p), 75 1 unbalanced (NTSC)
C signal = 0.3 V(p-p), 75 1 unbalanced (PAL)
Encoding format : ISO/IEC13818-2 (MPEG-2 video)
Quantization : 8 bit
Sampling rate : 13.5 MHz
Ⅵ Audio Signals
Line input
: –8 dBs, 10 k 1 minimum, unbalanced
+4 dBs, high impedance, unbalanced
Line output : –8 dBs, 1 k 1 minimum, unbalanced
Standard level : –20 dBFS
Dynamic range : 85 dB
Recording format : LPCM / DOLBY DIGITAL / MPEG (PAL only)
Quantization : 16 bit
Sampling rate : 48 kHz
Number of channels: 2
Ⅵ DV Interface
I/O
: IEEE1394
Ⅵ General
FOOT SWITCH terminal : 3.5 mm Monaural mini jack (OPEN/SHORT
control, Operation follows menu settings.)
Network terminal : RJ-45 (Category5),
100 BASE-Tx
USB terminal : USB 1.1 × 2
Power supply : AC 100V to 240 V `, 50 Hz / 60 Hz
Power consumption : 1.0 A to 0.45 A
Weight
: 4.8 kg (device only)
Dimensions : 212 mm (w) × 352 mm (d) × 88 mm (h)
(not including feet and other protrusions)
Permissible operating temperature : 5°C to 35°C
Permissible operating humidity
: 20% to 80% RH
Permissible storage temperature : –20°C to 60°C
Permissible storage humidity : 5% to 80% RH
Ⅵ Accessories
Instruction manual ................................................................ ×1
Power cord ........................................................................... ×3
Ferrite core (for USB cable) ................................................. ×1
(
☞ Page 23)
DVI-HDMI cable ................................................................... ×2
Cable clamp (for DVI-HDMI cable) ....................................... ×1
(
☞ Page 13)
SDSP3
SDSP3
212 88 6.5
20
352
OPERATE
PHONES REV STOP PLAY
DVD RECORDER
FWD PAUSE REC
BUSY OPEN/CLOSE
TOP MENU MENU
OPTION DV Y/C LINE SET UP AUDIO CH1 CH2 TITLE DOLBY DIGITAL
LPCM MPEG CHAPTER
SET
* Design and specifications are subject to change without notice.
Ⅵ External Dimensions (Unit: mm)