John Lewis JLUCFRW6001 - Manual (Page 7)

7
It is recommended to deliver the appliance in original
packaging, in vertical position considering the
protective warning on packaging.
After positioning, the appliance must not be switched on for
approx. 2 hours to allow the refrigerant to settle.
Unpack the appliance and check if there are damages on it.
Report any damage immediately to the place where you
bought it. In this case retain packaging.
Cleaning
Remove all adhesive tape and packaging, which ensure the
accessories do not move in the appliance.
Wash the inside of the appliance using lukewarm water and
bicarbonate of soda (5ml to 0.5 litre of water).
After cleaning dry the inside of the appliance thoroughly.
Unpacking
Location
The appliance should be placed in a well ventilated, dry
room.
The appliance energy use is affected by the ambient
temperature.
The appliance should therefore:
not be installed next to radiators, cookers or other
sources of heat
only be installed at a location where the ambient
temperature corresponds to the climate classification, for
which the appliance is designed.
Climate Classification
The climate classification can be found on the rating plate
located inside the appliance.
The following table shows the ambient temperature for
each climate classification:
Climate Classification Ambient Temperature
SN +10 to +32 °C
N +16 to +32 °C
ST +18 to +38 °C
Ventilation Requirements
The appliance must have adequate ventilation to ensure
correct operation.
Diagram shows the ventilation requirements when
installed:
A: Under a worktop, or cupboard.
The clearance space of 10 cm above the appliance
may be reduced to 5 cm providing a clearance
space 2,5 cm is left on either side of the appliance.
B: When freestanding
2
1
Levelling
The appliance must be level. Level the appliance by
adjusting the two adjustable feet (1) at the front of the
appliance.
If required the washer (2) can be removed.