JVC HR-J589EU - Manual (Page 25)

Filename [HRJ680EU2.fm]
Masterpage:Right
EN
25
D
Set the tape speed.
Press SP/LP ( p ).
E
Set the VPS/PDC mode.
Press VPS/PDC to select “ON” or “OFF”.
● If “VPS/PDC ON” is displayed on the TV screen, VPS/PDC is
set to ON.
● If “VPS/PDC OFF” is displayed on the TV screen, VPS/PDC is
set to OFF.
੬
“VPS/PDC Recording” on page 27.
F
Return to the normal screen.
Press PROG or OK. “PROGRAM COMPLETED” appears
on the TV screen for about 5 seconds, then the normal
screen appears. If “PROGRAM OVERLAPPED” appears
on the TV screen, see page 29.
● Repeat steps 1 – 6 for each additional programme.
G
Engage the recorder’s timer mode.
Press # (TIMER). The recorder turns off automatically and
# appears on the front display panel.
● To disengage the timer mode, press # (TIMER) again.
NOTES:
● To Change The Stop Time . . .
. . . press STOP +/– after pressing OK in step 3. You can
compensate for anticipated programme schedule delays.
● To Timer-Record Weekly Or Daily Serials . . .
. . . after pressing OK in step 3, press WEEKLY (NUMBER key
“9”) for weekly serials or DAILY (NUMBER key “8”) for daily
serials (Monday — Friday). Either “WEEKLY” or “DAILY”
appears on the TV screen. Pressing the button again makes the
corresponding indication disappear.
● You can programme this recorder to timer-record as many as 8
programmes. If you try to programme the recorder to record a
ninth, “PROGRAM FULL” appears on the TV screen. To record
the extra programme, you must first cancel any unnecessary
programmes (
੬
pg. 28).
● It is not possible to timer-record a TV programme with a
S HOW V IEW number which starts with “0”.
● It is not possible to timer-record a satellite broadcast received
on the channel position “0” by the satellite receiver.
Satellite Receiver Users
To timer-record a satellite broadcast using the S HOW V IEW
system:
A Perform “Satellite Receiver Control Setting” on page 13.
B Perform steps 1 – 7. In step 5, you cannot set “VPS/PDC”
to “ON”.
C Leave the satellite receiver’s power on.
ATTENTION
Guide Program Number Set
“GUIDE PROG SET” appears after performing step 3 if the
Guide Program number for the S
HOW V IEW number you
entered has not been set.
If you want to set the Guide Program number for the satellite
broadcast station, press the NUMBER key “0” to change “TV
PROG” to “SAT”. Press
rt to input the channel position
number on which your recorder or satellite receiver receives
that station, then press OK or
e to set the Guide Program
number. The S HOW V IEW Program screen appears.
(Example)
To timer-record a ZDF
programme with the
S
HOW V IEW system.
* If your recorder receives ZDF on
the channel position 2, press OK
or
e
after entering “2”.
HRJ680EU2.fm Page 25 Tuesday, November 21, 2000 12:32 PM