Jumpking OR1213 - Manual (Page 15)

15
1. Make sure you understand the information in
the box at the top of this page before you
begin assembling the trampoline.
Lay three Top Tubes (1), (2) and (3) on the ground
as shown. Make sure there is a T-connector(4) on Top Tube
(1, A marking with bigger end), Socket(7) on the Top
Tube(2, B marking with bigger end) and T-connector(4) on
the Top Tube(3, c marking with bigger end).
Insert Top Tube(1, A marking with small end) into
Socket(7). Then insert Top Tube(1, 2) into Top Tube(3, C
marking with bigger end).
You have now assembled one leg section.
Repeat this step to assemble three more leg
sections.
1
Center
2, B marking 4
1, A marking
6
7
5
12
12
3, C marking
2
2. Note: This step requires two persons. During
this step, you will connect the four leg sec-
tions.
Hold two leg sections in the positions shown.
Insert the small end of Top Tube (3, C marking) into the
T-connector(4) on another Top Tube (1, A marking).
Repeat this step until all four leg sections are
connected.
Insert a center leg(6) into the leg(5). Tighten a
self-taping screw(12) into small hole in the leg(5).
Insert the leg (5) into the T-connector(4).
2
3 2
3
1
1
4
4
4
5
1
3
2
4
6
3
1
2