John Lewis JLFFW2004 - Manual (Page 11)

11
The elements of the temperature display are as follows:
1.Ambient symbol
Seen when the digits show the ambient temperature.
2. Refrigerator symbol
Dark, when the digits show the refrigerator temperature.
3. Freezer symbol
Dark, when the digits show the freezer temperature.
4. Digits
By default the digits show the ambient temperature and
the ambient symbol is seen.
The digits can show also:
The medium temperature inside the refrigerator after
pressing the "C" button (refrigerator symbol is dark), for
a while.
The highest temperature inside the freezer after
pressing the "C" button twice (freezer symbol is dark),
for a while.
Refrigerator temperature set (value is blinking) when
the "F" knob is rotated and for a while afterwards.
Freezer temperature set (value is blinking) when the "B"
knob is rotated and for a while afterwards.
5. Super cooling symbol
Visible, when the appliance runs in super cooling mode.
See also the chapteron freezing.
6. High temperature symbol
Visible, when the temperature in the refrigerator is too
high. See also the description on the display background
colour.
7. Shopping symbol
Visible, when the appliance runs in shopping cooling
mode. See also the chapter on using the refrigerator.
Display background colour
By default the display background is blue.
When ever a control button or knob is used the
background turns bright blue and remains so for a while.
The display background turns red, if the temperature
inside the freezer is too warm (alarm). If this is the case,
the digits blink the warmest temperature inside the
freezer, the high temperature symbol flashes and an
acoustic alarm signal is shown.
The temperature might be too warm in the following
cases:
Immediately after switching on
The freezer door was left open for a longer time
There is an operating trouble in the freezer
To switch the alarm sound off press the "E" button.The
display returns to showing the ambient temperature,
however the background remains red until the freezer
cools down properly.
Should you press no button during alarm, press the "E"
button when the sound finishes to see the warmest
temperature reached during the alarm.
Controlling the temperature,
setting
The Thermostat will stop and start the cooling system as
frequently as is required to maintain the temperatures
set within the two compartments.
Temperature of the refrigerator and freezer can be set
by knobs "F" and "B", respectively.The set temperature is
seen blinking on the display.
For everyday use the setting in the refrigerator should be
+5°C; in the freezer the setting would be -18°C
recommended, or slightly colder.
Allow the appliance to run for a period of 24 hours
whenever the temperature setting is changed. This will
allow the temperature to stabilise inside the appliance.
The temperature within the refrigerator is influenced by
varying factors, the thermostat setting, the ambient room
temperature, the frequency that the door is opened and
closed and the quantity of food stored within.
When the coldest temperature possible is set -
when there are eases of increased demand e.g.
during heatwaves - the compressor may operate
continually. This does not cause damages to the
appliance.