JVC HR-S7960E - Manual (Page 55)

Masterpage:Right-NoTitle0
EN
55
Filename [HRS7960E5-EN.fm]
Page 55 April 22, 2003 3:07 pm
Manual Channel Set
Store channels that were not stored during Auto Set Up
(
੬
pg. 12), Preset Download (
੬
pg. 14) or Auto Channel Set
(
੬
pg. 53).
A
Access the Main Menu screen.
Press MENU.
B
Access the Confirmation screen.
Press
rt
to move the highlight bar (pointer) to
“MANUAL CH SET”, then press OK or
e
. The
Confirmation screen appears.
C
Select the channel position.
D
Select the band.
E
Input the channel.
Press the number keys to input the channel number you
want to store.
● Input “0” before any single number entries.
● To input the registered station name (ID – ੬
pg. 58), press e
until “– – – –” (ID setting) begins blinking, then press rt .
● For fine tuning adjustment, press
e until “+/–” begins blinking,
then press rt . While tuning, “+” or “–” appears.
● When storing a channel that sends scrambled broadcasts,
press e until “OFF” (Decoder setting) blinks, then press rt
to set “DECODER” to “ON” (“OFF” is the default setting).
● When “L-2 SELECT” is set to “A/V” or “SAT”, the “DECODER”
setting cannot be changed (
੬
pg. 43).
F
Enter new channel information.
Press OK and the Confirmation screen appears.
● Repeat steps 3 – 6 as necessary.
G
Close the Confirmation screen.
Press MENU.
● To change positions, see “Change Station Channel Position”
(
੬
pg. 56).
● If you wish to set station names other than the ones registered
in your recorder, see “Set Stations (B)” (
੬
pg. 57).
Press
rt w e
until an open
position in which you want to
store a channel begins
blinking, then press OK. The
Manual Channel Set screen
appears.
(Example) To store in position 12.
The blueback screen and the
programme currently being
broadcast by the selected channel
appear alternately for 8 seconds
each.
Press
rt
to change the band
between CH (regular) and CC
(cable), then press
e
.
HRS7960E-EN.book Page 55 Tuesday, April 22, 2003 3:07 PM