IGo Direct PPC 6700 - Manual (Page 4)

Installing the Mouse for Use with Windows XP
Before You Begin
¾ Determine that your PC is Bluetooth-enabled with either a built-in
Bluetooth component, or via an external hardware adaptor (Dongle).
¾ Ensure that the accompanying Bluetooth software (Stack) is installed.
¾ It is not necessary to disable or remove your existing mouse
software. (Refer to the User’s Guide included with your PC with any
questions on your current mouse.)
¾ Insert the 2 AAA batteries (included) beneath the battery cover of the
Stowaway Bluetooth mouse.
Creating a Paired Connection with your PC
1. Install the Bluetooth Dongle, if necessary, and launch the accompanying
Bluetooth software on your PC.
2. Refer to the instructions included with your Bluetooth software on the
process for Pairing Devices.
3. Power on the Stowaway Mouse by switching the Power switch to ON and
press the Discoverable button to make it detectable by the Bluetooth
software on your PC.
4. Begin device detection, and locate the Stowaway Mouse among any found
devices.
5. Establish a link between the computer and the Stowaway Mouse. (Refer
to the User Guide included with your Bluetooth software for instructions
on how to do this.)
6. After the mouse is successfully linked with your PC, the mouse pointer
will immediately begin responding to movement and button presses,
similar to your standard mouse. Refer to the User Guide for your PC on
the Windows Control Panel Mouse applet to modify mouse functionality
within Windows.
NOTE: The remainder of this document primarily addresses the Stowaway
Mouse for use with Pocket PC / Windows Mobile2003-enabled PDAs.
Stowaway Bluetooth Mouse Owner’s Manual
Page 4