IKEA FRAMTID OV9 - Manual (Page 12)

Inserting the door and the glass panel
When the cleaning procedure is completed,
insert the glass panel and the oven door. To
do so, follow the steps in reverse.
The inner glass panel must be assembled
keeping the decorative frame (screen-print-
ing) turned towards outside of the oven. To
double check you did the above operation in
a proper way simply pass your fingers on the
inner glass surface. If the panel of glass is as-
sembled correctly you should not feel any
roughness.
Insert the internal panel of glass into the right
seats as shown below.
Side rails
To clean the side walls of the oven cavity, re-
move the side rails.
1
Pull the rails away
from the oven wall
at the front.
2
2
1
Then unhook the
rails at the back.
To put the side rails back, follow the instruc-
tion in reverse.
Important! The rounded ends of the guide
bars must point to the front.
Changing the oven lamp and cleaning the
glass cover
Warning! Before you change the oven
lamp (refer to "Product description"),
switch off the appliance and disconnect it
from the electrical supply.
1. Turn the glass cover anti - clockwise and
remove it. Clean the glass cover.
2. If necessary, replace the old oven lamp
with a 15/25 watt, 230V (50Hz), 300 °C
heat resistant oven lamp (Connection
type: E14).
3. Refit the glass cover.
ENGLISH 12