Section 4—arms, Adjusting armrests, Angle – Invacare Van Seat PHWH93 User Manual
Page 15: Height
SECTION 4—ARMS
15
SECTION 4—ARMS
ƽ WARNING
After ANY adjustments, repair or service and before use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.
Adjusting Armrests
ƽ WARNING
Pinch point may occur when adjusting the arm angle position (Detail “A”).
Angle
NOTE: For this procedure, refer to Detail “A” of FIGURE 4.1.
1. Lift up the armrest.
2. Loosen the jam nut.
3. Adjust the socket screw up or down to the desired arm angle position.
4. Tighten the jam nut.
5. To determine the same angle for the
opposite armrest, count the exposed
threads after the jam nut has been
tightened.
6. Repeat STEPS 1‐4 for opposite armrest,
if necessary.
Height
NOTE: For this procedure, refer to Detail “B”
of FIGURE 4.1.
1. Remove the socket screw that secures
the armrest to the seat frame assembly.
2. Adjust the armrest to one of four
positions.
3. Reinstall the socket screw that secures
the armrest to the seat frame assembly
and tighten securely.
FIGURE 4.1 Adjusting Armrests
DETAIL “B” - HEIGHT
DETAIL “A” - ANGLE
Armrest
Adjustment
Screw
Armrest
Height Adjustment
Holes
Seat Frame
Assembly
Lock Knob
Jam Nut