iHome ID28 - Manual (Page 12)

9
Listening to iPhone/iPad/iPod
Listening to FM Radio
Setting up the Antenna
Insert the FM Antenna plug into the Aux-in/FM Antenna Jack on the back of the unit. Extend the wire antenna fully for best
reception. Do not strip, alter or attach to other antennas.
Tuning and Playing the FM Radio
1. Press the Radio/AUX Button as needed to turn the unit on and toggle between FM radio and aux-in modes. Select FM
Radio mode. The last selected radio station will play and the frequency will appear in the display.
2. Press the or Button to tune radio to a desired station. Pressing and holding the or Button (2 sec. then
release) will seek the next clear FM radio station.
3. Press the Volume or Button to adjust the volume setting.
4. If needed, move the radio mono/stereo switch located on back of the unit to mono to improve reception/signal.
5. To turn off the unit, press the Button. iPhone/iPod will continue charging while in the dock.
Setting and using FM Presets
You can set and save up to 6 radio station presets in memory.
1. To set a station as a preset, enter FM radio mode (see above).
2. Press the
Presets Button as needed to step through the presets (1 - 6) to the desired preset number.
3. Press and hold the Presets Button until the display flashes, then press the or Button to tune to the desired station
for the preset number (press and hold or briefly to scan to the next clear FM station).
4. Press the
Presets Button to confirm your preset. To continue setting presets, follow steps 2-3 above).
1. Gently dock an already playing iPhone, iPad or iPod. The unit will automatically turn on and you will hear the audio playing
from your iPhone/iPad/iPod.
Note: If the playing audio loudness is too low on the iPhone/iPad/iPod, the iD28 may not detect that the
iPhone/iPad/iPod is in play mode. Press the Button to play it.
2. Press the or Button to change iPod/iPhone track forward/reverse.
3. When the iPhone/iPod is docked and in standby mode, press the Button to play it.
4. When the iPhone or iPod is in play mode, press the Button to pause play; press again to resume play.
6. Press the Volume or Button to adjust the unit volume.
7. Press the eq Button as needed to cycle through treble, bass and SRS™ sound settings. Press the or Button to
adjust settings for best sound. When the SRS circuit is switched 'On' the SRS indicator will appear in the display.
8. To turn off the unit, press the Button. Your iPhone/iPod will continue charging while in the dock if unit is connected to
AC power. It will not charge when running on internal battery.