iHome iH120 - Manual (Page 7)

Pressing and holding FWD/REW while iPod is docked will scan forward/reverse
within currently playing track.
4
Install/Replace the Remote Control Battery
The remote control battery is already installed at the factory. When the
remote control stops operating or its range seems reduced, it is time
to replace the battery with a new one.
1. The battery door is located on the back end of the remote control.
2. Pull the battery door to release the battery door latch and take out
the battery.
3. Insert a CR2032 battery, checking that the + and – sides of the
battery matches the drawing inside the battery compartment.
4. Replace the battery door.
Note: Make sure you dispose of batteries properly (see your local regulations).
The Remote Control controls basic functions on the iH120 and certain iPod functions when the iPod is docked in the iH120.
For best results, aim remote control towards the remote sensor on the upper left corner of the unit.
To check for iPod compatibility
iH120 is an advanced system and supports most updated iPod features. To ensure your iPod works properly with the iH120,
please update your iPod firmware with the latest version, available via iTunes.
ᕤ
Installing Remote Battery
ᕢ
ᕣ
Install/Replace the Remote Control Battery
Using the Optional Remote Control
Power Button turns unit OFF or Reset Alarm.
Pressing Play/Pause from power off mode will play iPod.
Pressing Play/Pause while iPod is docked and playing will pause iPod.
Press again to resume play.
Remote not included
with all iH120
models.
To order a remote,
please visit
www.ihomeaudio.com
Volume Buttons raise and lower volume on the unit.
Pressing the sleep mode function same as on main unit.
Pressing the snooze/dimmer mode function same as on main unit.
Pressing the mute button will mute unit.
Pressing FWD/REW while iPod is inserted will FWD/REV to next/previous track