Iqua UFO Portable Handsfree User - Manual (Page 8)

6
To start pairing for the first time, follow these steps:
1. Make sure that the battery is charged.
2. Switch on the UFO.
3. Press both the button and the button at the same time for a couple of seconds.
4. The UFO will be available for new compatible Bluetooth devices within its operating
range. A Bluetooth symbol will flash in the upper right corner of the phone display to
indicate that pairing is in progress. When the phone has found the device, you will see
Iqua UFO on the phone display. Select Yes and enter the UFO ID code 0000.
5. Once pairing has been successfully completed, you will hear a long beep and the
Bluetooth symbol on the phone display will stop flashing to indicate an active connection
between the UFO and the phone.
If the UFO has already been paired with a phone, it will find this phone the next time it is
switched on and pair with it automatically.
If you want to cancel pairing, or if the UFO does not find a phone to pair with, you can stop it
from trying by pressing the
button. To try again, repeat the steps above.
Disconnecting the UFO and the phone
To disconnect the UFO and the mobile phone, do any of the following:
1.
Turn off the UFO.
2. Disconnect the UFO through the menu in your phone.
3. Move the UFO more than 10 meters away from the phone.
The UFO will also be disconnected if the battery is empty.
UFO_PHF-601_UG_en.fm Page 6 Wednesday, June 7, 2006 1:20 PM