Image 831.10815 - Manual (Page 7)

7
1. Before beginning assembly, be sure that you
have read and understand the information in the
box above and on page 6.
Place the Surround Bottom (45) and the pre-
attached Spa Surround (9) on the ground in the
location you have chosen for assembly. Unfold the
Spa Surround until it is round.
Open the Inflatable Liner (29). Lay the floor of the
Inflatable Liner (the side with the triangular pattern)
on the bottom of the Spa Surround (9). Pull the liner
wall up, making sure that the three indicated
holes in the Inflatable Liner are centered in the
cutout in the Spa Surround.
Attach the flap on the top edge of the Inflatable Liner
(29) to the fastener strip on the edge of the Spa
Surround (9). Start the flap where the fastener strip
starts and pull the flap tight as you go around. Make
sure the three holes in the Inflatable Liner are
centered in the cutout in the Spa Surround (9),
as shown in the inset drawing.
1A
29
Before beginning assembly, carefully read the
following information and instructions:
• Place all parts in a cleared area and remove the
packing materials; do not dispose of the packing
materials until assembly is completed.
• Read all assembly steps before you begin.
• Assembly requires only the included air pump.
Note: The included flat wrench is not required for
assembly. The flat wrench is used to remove the
filter cap (see pages 10 and 11).
• Make sure that all parts are oriented as shown in
the drawings.
9
45
Holes
Cutout
Fastener
Strip
Assembly
1B
9
29
Flap
Fastener Strip
Cross
Section
View from the Outside
Cutout
Holes in Inflatable Liner