Image 831.10815 - Manual (Page 3)

3
WARNING: To reduce the risk of drowning, electric shock, or serious injury, read the following
important precautions before using the spa.
READ AND FOLLOW ALL INSTRUCTIONS
1. It is the responsibility of the owner to ensure
that all users of the spa are adequately
informed of all precautions.
2. Use the spa only as described in the manual.
3. The spa is intended for home use only. Do
not use the spa in any commercial, rental or
institutional setting.
4. Use the spa only on a level surface. Do not
use the spa on carpet or other materials that
could be damaged by moisture. Do not use
the spa on rough or sharp surfaces such as
gravel or wood chips.
5. The spa will weigh approximately 2,339
pounds when it is assembled and filled with
water. Be sure that the location you select for
the spa will support this weight, plus the
weight of the occupants.
6. Inspect and tighten all parts regularly.
Replace any worn parts immediately.
7. DANGER—Risk of injury: Do not remove or
alter the covers on the suction fittings. Never
operate the spa if the suction guard is miss-
ing or broken. Keep hair and body away from
the suction guard. If you need to replace a
suction fitting, be sure that the flow rate of
the replacement is compatible.
8. Do not bring any object into the spa that
could puncture the liner.
9. Never insert any object into any opening.
10. Do not sit on the spa cover or place objects
on it; it is not designed to support weight.
11. Remove any water that may collect on the
spa cover.
12. Keep children and pets away from the spa
when it is not in use.
13. Keep all chemicals away from children and
pets.
14. The pH and chemical balance of the water
must be maintained as explained in this man-
ual (see page 13). Failure to do so may cause
injury to users or damage to the spa jet unit,
and will void the warranty.
15. The water pump in the spa jet unit must be
primed before you use the spa the first time.
You must also prime the pump before using
the unit each time you refill the spa or clean
the filter. The spa jet unit may be seriously
damaged if the pump is not properly primed
(see PRIMING THE SPA JET UNIT on page
10).
16. DANGER—When connecting the power cord
(see PLUGGING IN THE SPA on page 10),
plug the power cord directly into a grounded
circuit capable of carrying 15 or more amps.
No other appliance should be on the same
circuit. Replace the power cord immediately
if damaged.
17. Do not use an extension cord with the spa.
This could damage the motor and the electri-
cal system and it will void the warranty.
18. DANGER—If you will be using the spa out-
side, do not bury the power cord; you should
also keep the power cord away from lawn
mowers, hedge trimmers, and other similar
equipment.
19. WARNING—The power cord is equipped with
a Ground Fault Circuit Interrupter (GFCI),
located at the end of the power cord. The
GFCI must be tested before each use. To test
the GFCI, press the “test” button while the
spa jet unit is running. The spa jet unit
should shut off. Press the “reset” button.
The spa jet unit should resume normal oper-
ation. If the spa jet unit continues to run after
the “test” button is pressed, then the GFCI is
damaged. Do not use the spa until the GFCI
Important Safety Instructions