Infinity CAS 2.1 - Manual (Page 8)

8 CAS 3.1/CAS 2.1
Step 6
Insert the four rubber grommets that retain the grille posts into
the screw hole on the front, as shown. The grille has two side
clips that look like wings. These extend about 1/4." See
illustration. Note the side flange areas that catch the clips. Make
sure these side clips are extended before attaching or removing
the grille. Extend the side clips and attach the grille, reclipping it
once in place.These side clips push inward to lock the grille
onto the speaker.
For Removal
Step 1a
Pull out side clips on sides of the grille. Pull grille off.
Step 2a
Remove the rubber grommets from the holes to access screws.
It is best to use a #2 Phillips screwdriver to gently pry the
grommet out. Unscrew the four baffle-retaining screws
and carefully remove the speaker housing. Disconnect the
speaker wires.
Step 3a
Fully unscrew all of the clamps around the speaker housing. The
clamp screws have a stop on them so you do not have to worry
about accidental disassembly. Now move the speaker housing out
from the wall enough to wedge your hand behind and pinch a
clamp shut. While the clamp is shut, work the speaker housing
forward enough to catch the shut clamp in the wall opening.
Work your way around the perimeter, carefully doing this to each
clamp and remove the speaker housing from the wall.
¤ ¤
SIDE FLANGE
AREAS
GROMMET
GRILLE
NOTE THAT THE
SIDE CLIPS ARE
PULLED OUT 1/4"