Infinity CAS 2.1 - Manual (Page 7)

7 CAS 3.1/CAS 2.1
Step 5
Place the supplied fiberglass insulation in the rear of the
mounting frame. Place the cardboard shim on top of the lower
front ledge of the frame, as shown. The cardboard shim is for
aligning the baffle assembly properly within the speaker
mounting frame. Lift the speaker baffle up and place it on the
shim. Connect the speaker wires as shown on pages 9 and 10
and slide the baffle into place. Be sure that as you slide the
speaker baffle assembly into place, the speaker wires are clear
of the woofer basket and do not get pinched between the baffle
and the mounting frame. Insert the four screws through the
inserts into the holes and tighten by hand just until snug.
WARNING: If you overtighten these screws, it may cause the
“isolators” to become overcompressed and they will no longer
function correctly. Maximum tightening of these screws is no
more than 16-inch-pounds. Remove baffle shim when complete.
SCREWS
INSERTS
REMOVE SHIM AFTER
SECURING SCREWS
CARDBOARD SHIM
SPEAKER BAFFLE SPEAKER WIRES
FIBERGLASS
INSULATION FIBERGLASS
INSULATION
SPEAKER WIRES MOUNTING FRAME
BAFFLE ASSEMBLY
CARDBOARD SHIM
SCREWS
INSERTS
REMOVE SHIM AFTER
SECURING SCREWS