Zyxel NWA-3160 - Manual (Page 13)

ENGLISH
13
"
Make sure the screws are securely fixed to the wall and strong enough to
hold the weight of the ZyXEL Device with the connection cables.
2 Adjust the cables.
Run the connection cables down the back of the ZyXEL Device as shown in the following
figure.
OR:
Run the connection cables upward and along the edge of the ceiling.
"
You can also use the optional Ceiling Mount Kit (sold separately) to mount
the ZyXEL Device on a ceiling instead of a wall.
5 Set Up Power over Ethernet (Optional)
Power over Ethernet (PoE) is the ability to provide power to your ZyXEL Device via an 8-
pin CAT 5 Ethernet cable, eliminating the need for a nearby power source.
3 Align the holes on the back
of the ZyXEL Device with
the screws on the wall.
Hang the ZyXEL Device on
the screws.
140mm