IBM L180p - Manual (Page 19)

Normally, you can complete the setup procedure using Automatic Image s etup;
however, if your screen image is still distorted after you perform Image s etup or
the setup CD does not run on your system, perform M anual Image s etup .
To manually adjust the image setting, do the following:
1. Turn on the monitor and wait approximately 15 minutes for it to warm
up.
2. Display the image you most frequently use on the screen.
3. Press the OSD Enter button " " at the bottom of the monitor to display
the initial OSD menu.
4. Use the Right Arrow button " " to select the Image s etup icon " "
and press the OSD Enter button " " to access the function.
5. Use the Right Arrow button " ", to select to manual. Press the OK
button " " twice to select clock.
6. Use the Arrow buttons to manually adjust to correct for jitter or noise in
the image. Press OK button " ".
7. Press OK " " and use Arrow buttons to adjust phase, press OK " ".
Press OK " " again to Save and Exit. Then press Exit button " "
twice to exit OSD.
You have completed the monitor setup.
ENGLISH
17
i If the monitor is in standby
mode , it might automatically
turn off while you are waiting
for it to warm up.
Manual Image s etup