Ingersoll-Rand NO SE ENCUENTRA 150BMG - Manual (Page 6)

6 03524832_ed12
150BMG Series Air and Gas Starters Typical Installation
T
o
rq
ue (lb
-f
t)
P
o
w
e
r (HP)
F
lo
w
(SCF
M)
Series 150BM and 150BMG Performance Curves
0
20
40
60
80
100
120 25
20
15
10 300
600
900
1200
5 0
0 500 1000 1500
Speed (RPM)
2000 2500 3000
Starter
3BM, 5BM 0-30’ # 12 (3/4 “) SRV 100
SRV 100
SRV 100
SRV 125
SRV 150
# 12 (3/4 “)
# 16 (1 “)
# 20 (1 1/4“)
# 24 (1 1/2“)
0-30’
0-10’
10-30’
0-50’
SS175
150BM/LF, SS350
SS810, 815, 825, 850
ST750, 799
Hose Length Hose Size SRV Size
The performance of the Starter is dependent on the pressure at the inlet of the starter.
This pressure is effected by the pressure drop between the Air Receiver Tank and the Starter.
The most significant pressure drops will occur in fittings (Valves, Tees, Elbows, etc.)
The next significant source of pressure drop is the hose. The following table provides
recommended hose and Starter Relay Valves (SRV) sizes for typical one starter installations.
Systems with many fittings or long hose should be analyzed and sized individually.
For Gas Operation the exhaust outlet must be piped
away to a safe location.
For Natural Gas Operation, Piped Exhaust must be
used and Drive Housing vent plug replaced with
suitable hose which connects into piped exhaust
system.
For Air Applications a Muffler or Splash Guard
Deflector must be used.
Ingersoll Rand Part Number
Starter control Valve
SMB-G6618
Air Pressure Gage
150BMP-1064L
Check Valve
150BMP-1056
Drain Valve
150BMP-1067
1/2 NPT
# 4 Hose (1/4”)
# 4 Hose (1/4”)
# 4 Hose (1/4”)
JIC 37˚ Adapter
1 1/2 NPT
Air
Receiver
Tank
1 1/2” NPT
HDL3 Luricator
See Recommended
Hose Size
JIC 37˚ Adapter
1/4 NPT
Air Supply
Note:
Use Seleant on all pipe connections.
SMB-441
(Dwg. TPC585)
(Dwg. TPC611)