Setting up the ih110, Charging your ipod – iHome iH110 User Manual

Page 7

Setting the Clock Time

Note: Press the Clock Adj. Button once during normal operation to view the current time display format (12 hour or 24 hour

format). 12 hour is the default format.

1. Press and hold the Clock Adj. Button for 2 seconds until the display flashes. Press the UP or DOWN Button until the

current time is displayed.

2. For 12 hour or 24 hour time format setting: Press the Alarm Set Button during time setting to set 12-hour or 24-hour

display format. Remember to set the correct AM or PM time (an icon to the right of the time display is the PM indicator;

there is no AM indicator). Note that the PM indicator will not appear when using 24 hour display mode.

3. Press

the

Clock Adj. Button again to confirm the clock setting. You should hear 2 beeps indicating the clock time is set.

4. During daylight saving time, set the DST Switch located on the back of the unit to +1 to advance the time one hour. The

DST Icon will appear on the display to indicate DST is on. Set the switch to -1 to set the time back one hour at the end

of daylight saving time.

Setting Up the iH110

Note: Please make sure you are using the correct insert for your iPod (see page 1) and that it is properly docked into the

iH110. Failure to do so may damage your iPod.

1. While your iPod is docked in the unit and the unit is connected to AC power, it recharges (until fully charged). The iH110

will not overcharge your iPod. Note that other non-docking iPods will NOT charge.

Charging your iPod