iHome iH22 - Manual (Page 8)

This unit is a PRESET Clock: the time is already preset at the factory. Simply match the time zone setting to where you live.
1. Depending on your location and whether or not Daylight Saving Time (DST) is in effect, set the DST Switch located
on the back of the unit to +1 to add an hour or to -1 to subtract an hour to/from the currently displayed time.
2. Press and hold the Time Zone Button located on the back of the unit until the current time zone flashes. Press the
or Button to select your time zone.
3. Press the Time Zone Button again (or no button within 10 seconds) to exit the setting mode.
4. If time displayed is not correct, see Setting Time and Calendar to set the clock.
Setting Time and Calendar
1. Press and hold the Clock Adjust Button located on the back of the unit until the current time flashes on the display.
Press the or Button to adjust to correct time (holding the button for few seconds will advance or reverse rapidly).
2. Remember to set the correct AM or PM time. The PM Indicator is located above the minute digits.
3. Press the Clock Adjust Button again to adjust year. Press the or Button until the current year is displayed.
4. Press the Clock Adjust Button again to adjust month and date. Press the or Button until the current month/date
is displayed. Holding the button for a few seconds will advance or reverse rapidly.
5. Press the Clock Adjust Button again (or no button within 10 seconds) to exit the time/calendar setting mode. You will
hear two beeps to confirm Time and Calendar setting are completed.
Using the Alarms
Setting the Alarms
1. By default, the unit selects iPod as your wake source. If no iPod is docked or detected, the iH22 will automatically default
to buzzer alarm.
Note: make sure you have an hour of audio on your iPod.
2. Press and hold the Button until the current alarm time flashes in the lower part of the display. Press the or Button
to set the alarm time. Remember to set the correct AM or PM time.
3. Press the Button (or if no button is pressed within 10 seconds). Two beeps will confirm alarm time and exit alarm
setting mode. The alarm will be armed and the corresponding alarm icon will appear.
4. To set Alarm 2 just follow steps 2 - 3 using the Button.
Reviewing, Arming and Disarming Alarm (Turn Alarm Function On and Off)
1. Once an alarm is set, it is armed and the lower part of the display will show the alarm time. If both alarms are armed,
the earliest alarm time will show.
2. To arm/disarm the alarm, just press the associated alarm button to toggle it on or off. If the alarm is armed, the related
alarm icon will appear in the upper part of the display.
Resetting the Alarm to Come on the Next Day
1. When the alarm is sounding, press the Button to stop alarm and reset it to come on the following day.
Using the iH22
4