Image IMHS20701 - Manual (Page 10)

10
USING THE RENEW 207
The RENEW 207 is designed to seat two adults. The
spa holds 150 gallons of water and offers an automat-
ic, programmable heating (70¡ F to 104¡ F) and filtra-
tion system. Seven thera-jets soothe and relax tired,
sore muscles, and the strength of the massage is
adjustable. Follow the guidelines below to use and
maintain the spa for your long-term enjoyment.
PLUGGING IN THE RENEW 207
Once the RENEW 207 is filled with water, the power
cord can be plugged in and the spa can be turned on.
Note: The first time the power cord is plugged in, the
spa will turn on automatically.
When connecting the power cord, plug the power cord
directly into a grounded circuit capable of carrying 15
or more amps. No other appliance should be on the
same circuit. Replace the power cord immediately if it
becomes damaged.
There is a
Ground Fault
Circuit
Interrupter
(GFCI) on the
end of the
power cord.
Always test
the GFCI
before using
the RENEW
207.
First, turn on the RENEW 207 by pressing the pump
control on the console. Once the unit is running, press
the GFCI ÒtestÓ button. The spa should shut off. Press
the ÒresetÓ button. The spa should resume normal
operation. If the spa continues to run after the ÒtestÓ
button is pressed, the GFCI is damaged. Do not use
the spa until the GFCI has been repaired or replaced
by a qualified electrician.
Test and Reset
Buttons
Grounded
circuit capable
of carrying 15
or more amps
GFCI
POSTING THE WARNING SIGN
The included warning sign, shown below, must be posted on a wall or fence where it will be visible to all
users of the RENEW 207. If the spa is moved, the sign must also be moved and reposted near the spa. If
the sign becomes lost or illegible, call our toll-free Customer Hot Line at 1-877-897-7493 to obtain a free
replacement sign. Post the sign as described above.